Troubleshooting guide
The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures.
General
Problem | Cause/Solution |
|
|
No sound | •Adjust the volume with (+). |
| •Set the fader control to the centre position for |
| systems. |
The contents of the memory have been erased.
•The power cord or battery has been disconnected.
•The reset button has been pressed.
nStore the settings again into the memory.
No beep sound | • An optional power amplifier is connected and you are not |
| using the |
| • The beep sound is cancelled (page 8). |
|
|
CD playback
Problem | Cause/Solution |
|
|
CD cannot be loaded. | • Another CD is already loaded. |
| • The CD was forcibly inserted upside down. |
|
|
Play does not begin. | Dirty disc. |
|
|
CD is automatically ejected. | The ambient temperature exceeds 50°C. |
|
|
CD will not eject. | Press the 6button for two seconds. |
|
|
The operation buttons do not | Press the reset button. |
function. |
|
The sound skips due to | • The unit is installed at an angle of more than 60°. |
vibration. | • The unit is not installed in a sturdy part of the car. |
Radio reception
Problem | Cause/Solution |
|
|
Preset tuning is not possible. | • Memorise the correct frequency. |
| • The broadcast signal is too weak. |
|
|
Automatic tuning is not | The broadcast signal is too weak. |
possible. | nUse manual tuning. |
|
|
The “STEREO” indication | •Tune in the frequency accurately. |
flashes. | •The broadcast signal is too weak. |
| nSet to the MONO mode (page 7). |
|
|
12