1 Remove the screw at the bottom of the speaker.
2 Turn the speaker stand opposite 180˚, and then lightly tighten the screw.
Note
Do not turn the speaker stand more than 180˚.
The cord may become disconnected.
3 Tighten the screw again after adjusting the angle of the speaker.
4 Install the speaker on the wall.
Install screws (not supplied) in the wall and mount the satellite speaker by the hollow for the screw in the bottom of speaker. You can adjust the angle of the satellite speakers by selecting the hollow on the speaker.
The middle hollow is used to attach the speaker straight on the wall. The right or left hollow is used to attach the speaker on the wall at an angle.
Notes
•When you loosen or tighten the screw at the bottom of the speaker, use an appropriate driver.
•Be sure that the cord between the satellite speaker stand and the speaker is not pinched.
•If you install the speaker to a wall, make sure the wall you install to is strong enough. Since the speaker is heavy, it is dangerous if it falls. Sony cannot take any responsibility for any injury or damage during installation of those speakers.
continued
Started Getting
9GB