The Auto Rec Level function automatically measures the peak signal level and adjusts the recording level accordingly.
PAUSE P REC r ·
|
|
|
|
|
| AUTO |
|
|
|
|
|
| DIRECTION | DOLBY NR | REC LEVEL | ||
|
|
|
| D a RELAY OFF | B C | 4 | 5 6 | |
|
|
|
|
|
| 3 |
| 7 |
|
|
|
| SYNCHRO DUBBING A→B | 2 |
| 8 | |
|
|
|
| HIGH/NORMAL | FADER | ARL |
|
|
|
|
|
| START(DECK B P) | 1 |
| 9 | |
| DECK A |
| DECK B | PAUSE | REC MUTE | REC | 0 | 10 |
| COUNTER RESET | P | R | r |
|
| ||
| 0 |
| ) | 0 | ) |
|
| PHONES |
POWER | p | ª | · | p | ª | · |
|
|
|
|
| § | § |
|
|
|
|
1Follow Steps 1 to 3 of “Recording on a Tape” on page 6.
Make sure that
2Press REC r.
The AUTO indicator flashes and the deck automatically adjusts the recording level. The AUTO indicator lights up continuously after the recording level has been adjusted.
3Press PAUSE Por ·. Recording starts.
To cancel the Auto Rec Level functionPress ARL or turn REC LEVEL so that the AUTO indicator goes off. If you do either of these during recording, recording will continue but with the Auto Rec Level function turned off.
To stop recordingPress p.
zWhat is the Auto Rec Level function?The Auto Rec Level function automatically sets the recording level according to the peak signal level of the program source. While the AUTO indicator is flashing, the deck sets the recording level as high as possible without causing distortion. If the signal level rises excessively after the start of recording, the deck gradually decreases the recording level.
zYou should adjust the recording level manually with REC LEVEL in the following cases:
During a quiet passage in a program source such as classical music, the recording level may not increase for some time. If a high sound level is expected later on in the track, play that portion first so that the right adjustment can be obtained.
•To prevent changes in the recording level after recording starts, press REC rwhile playing the highest sound level portion of the program source to be recorded. The result is a more
•If you play the entire program source after the AUTO indicator has stopped flashing and is lit continuously, the deck will set the recording level for the portion of the program source with the highest signal level.
zRecording level setting remains even after the recording has endedAfter you have finished recording with the Auto Rec Level function, the AUTO indicator remains on and the recording level setting remains the same. To cancel the setting, do one of the following:
•Press ARL to turn off the AUTO indicator
•Turn REC LEVEL
•Turn the deck off.
8EN