Sony Model TC-WE405 Setting the voltage selector (only on models supplied with a voltage selector), Unpacking, Hooking Up the System, Hookups, Getting Started, Where do I go next

Getting Started

Unpacking

Check that you received the following items:

• Audio connecting cords (2)

Hooking Up the System

This section describes how to hook up the tape deck to an amplifier. Be sure to turn off the power of each component before making the connections.

To purchasers of the TC-WR661

Hookups

When connecting an audio connecting cord, be sure to match the color-coded cord to the appropriate jacks on the components: Red (right) to Red and White (left) to White. Be sure to make connections firmly to avoid hum and noise.

Connect the tape deck to the amplifier as shown below.

TapeÇdeck	Amplifier
LINE	TAPE
IN OUT	REC OUT	IN
L	L	L
R	R	R

For information on connecting your tape deck to the TA- AV561 Amplifier, refer to the Operating Instructions included with the TA-AV561.

ç: Signal flow

ç

To purchasers of the TC-WE405

Follow the instructions below to connect your tape deck to an amplifier.

TC-WE405

to LINE IN to LINE OUT

to an AC outlet

to REC OUT to TAPE IN

Amplifier

to a

wall outlet

Setting the voltage selector (only on models supplied with a voltage selector)

Check that the voltage selector on the rear panel of the tape deck is set to the local power line voltage. If not, set the selector to the correct position using a screwdriver before connecting the AC power cord to an AC outlet.

TC-WE405		TC-WR661
VOLTAGE		VOLTAGE
	220V		220V
	240V		230–
			240V
	120V		120V

Connecting the AC power cord

Connect the AC power cord to an AC outlet.

Where do I go next?

Now you’re ready to use your tape deck.

For basic operations, go to pages 5 to 7; for advanced operations, go to the sections starting from page 8.

4EN