Sony MZ-E707 service manual 001 1 Adrs, Clearing the error display code

MZ-E707

4-6-2. Self-diagnostic mode

1.Set the TEST MODE.

2.With all the LCD display segments blinking on the set, press DISPLAY key and >B key, the Self-diagnostic mode is entered.

001 1 Adrs

	Simplified contents
History code

Error display code

3.Hereinafter, each time > N key is pressed, the reference information display changes as follows:

• Contents of the history codes

History code number	Contents
1	The first error that occurred.
N	The last error that occurred.
N-1	The first error from the last one.
N-2	The second error from the last one.
R	Total recording time ( – – – – is displayed
	for MZ-E707)

0XX	1	# # # #
0XX
	N	# # # #

0XX N1 # # # #

0XX N2 # # # #

0XX R – – – –

• Press .

key to go back to the previous display.

•Description of the error display codes

Contents of fault	Display code	Meaning of code	Simplified	Description
			contents
No error	00	No error	– – – –	No error
	01	Access target address illegally specified	Adrs	An attempt to access an abnormal address.
Servo system error	02	HIGH TEMP	Temp	HIGH TEMP
	03	FOCUS ERROR	Fcus	Focus off-center.
	04	SPINDLE ERROR	Spdl	Abnormal rotation of disc
TOC error	11	TOC ERROR	TOC
	12	READ DATA ERROR	Data
Power system error	22	LOWBATT	LBat	Instantaneous interruption detected.
	31	OFFSET ERROR	Ofst	Offset error
Offset error	32	FE_ABCD_OFFSET_ERR	ABCD	FE ABCD Offset error
	33	TE_ABCD_OFFSET_ERR	TE	TE ABCD Offset error
	34	X1_TE_OFFSET_ERR	X1TE	X1 TE ABCD Offset error

4-6-3. Clearing the error display code

After servicing, reset the error display code.

1.Set the TEST MODE.

2.Press the DISPLAY key on the remote control activates the self- diagnosis display mode.

3.To reset the error display code press X key on the remote con- trol when the code is displayed.(except for R - - - - display) (All the data on the 1st, N, N-1 and N-2 will be reset)

4.Press X key on the remote control again.

10