Sony MZ-NH700 device, combined, computer, computer, computer, computer, normally, this time, recorder is, not operate, Even though the, Tracks cannot be, does not operate

Symptom	Cause/Remedy
Tracks cannot be	• You cannot combine tracks recorded in different recording modes,
combined.	e.g., a track recorded in stereo and a track recorded in monaural; nor
	can you combine a track recorded with digital connection and a track
	recorded with analog connection.
The disc cannot edit	• The component does not support MDLP or Hi-MD.
on other component.	, Edit on other component that support MDLP or Hi-MD.

While using group function

Symptom	Cause/Remedy
The group function	• While using a disc without group setting, an attempt was made to select
does not operate.	some group-related menu.
	, Use a disc with group setting.
A track cannot be	• This is due to the MiniDisc system limitations (in MD mode only).
recorded to a new	Group information has been written to the area where the disc name is
group. A new group	stored. The disc name and track names are recorded in the same area,
cannot be created.	which can store a maximum of approximately 1,700 characters. If the
	total number exceeds this amount, a new group cannot be created even
	though group mode is on. It is also impossible to make group settings at
	this time.

While the recorder is connected to the computer

Symptom	Cause/Remedy
The recorder is not	• The dedicated USB cable is not firmly connected.
recognized by the	, Connect the dedicated USB cable firmly to the recorder and the
computer.	computer.
	• A USB hub is used.
	, Connect the dedicated USB cable directly to the USB port of the
	computer.
	• Network communication has failed.
	, Disconnect the dedicated USB cable, wait at least 2 seconds, and
	then reconnect it. If the recorder is still not recognized, disconnect
	the dedicated USB cable, restart the computer, and then connect the
	dedicated USB cable again
Even though the	• A USB hub is used.
recorder is	, Connect the dedicated USB cable directly to the USB port of the
recognized by the	computer.
computer, it does	• You are using the recorder at a place with vibration.
not operate	, Use the recorder at a place with no vibration.
normally.
The recorder cannot	• The SonicStage or MD Simple Burner software is active.
be used as a storage	, Close the SonicStage or MD Simple Burner software.
device.	• A standard disc is inserted.
	, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD mode
	can be used as a storage media.

73