Messages
If the following error messages flash in the display window, check the chart below.
Error message | Meaning/Remedy |
|
|
BLANK | • An MD with no recording on it is inserted. |
| ,Insert a recorded MD. |
|
|
BUSY | • You tried to operate the recorder while it was accessing the |
| recorded data. |
| ,Wait until the message goes out (in rare cases, it may take |
| |
|
|
Edit | • The MD player is recording information (track start and end |
| position) from the memory to the disk. |
| ,Wait until this process is completed. Do not expose the |
| player to physical shock, nor disrupt power supply. |
|
|
ERROR | • The disc is damaged or does not contain proper recording or |
| editing data. |
| ,Reinsert the disc. If this fails, rerecord. |
|
|
FULL | • There is no more space to record on the disc (less than 12 |
| seconds in stereo, 24 seconds in LP2 stereo mode or monaural |
| or 48 seconds in LP4 stereo mode available). |
| ,Replace the disc. |
| • You tried to enter more than 200 letters to label a single track |
| or disc. |
| • You tried to enter a total of more than 1,700 letters for track or |
| disc names during playback or stop. |
| ,Enter a shorter name for track or disc, or delete “LP:” from |
| the beginning of the track name recorded in MDLP mode |
| (page 26). |
|
|
HiDCin | • Voltage of the power supply is too high (The recommended |
| AC power adaptor is not used). |
| ,Use the recommended AC power adaptor. |
|
|
HOLD | • The recorder is locked. |
| ,Slide HOLD against the arrow to unlock the recorder |
| (page 25). |
|
|
LoBATT | • Battery is weak. |
| ,Replace the dry battery (page 9). |
|
|
MEMORY | • You tried to record with the recorder placed where it receives |
| continuous vibration. |
| ,Put the recorder on a stable place, and start recording |
| again. |
|
|
36