Sony PAM-200 installation manual Attaching the Mount, Optional Hardware

PAM-200

Attaching the Mount

Unpack the PAM-200 and review any WARNING statements that apply to the installation. Select the desired location for the PAM-200.

M5 Allen Wrench

M4 x 10mm Security Head

Screw

1. Locate the mounting points on the bottom of the projector	2.	Line up the mounting holes on the PAM-200 with the
(see arrows above for mounting point recognition).		mounting points of the projector.
	3.	Use three (3) M4 x 10mm security head screws to attach the
		PAM-200 to the projector.
	4.	Tighten the security head screws down with a M5
		Security Allen wrench (supplied).
	5.	Do not overtighten these screws, as the threaded inserts can
		be damaged.

Optional Hardware

When mounting the PAM-200 to a Sony projector, it is imperative that the projector plate not cover any access plates that allow the user to access the interior of the projector. The following steps will allow the user to mount the PAM-200 projector bracket to the Sony projector without fear of blocking any ventilation access plates.

Nylon Spacer

M5 Allen Wrench

M4 x 16mm Security Head

Screw

Nylon Spacer

1.Locate the mounting points on the bottom of the projector (see arrows above for mounting point recognition).

2.Place the nylon spacers over the mounting points.

3.Line up the mounting holes of the PAM-200 with the nylon spacer mounting holes.

4.Use three (3) M4 x 16mm security head screws to attach the PAM-200 to the projector.

5.Tighten the security head screws down with a M5 Security Allen wrench (supplied).

6.Do not overtighten these screws, as the threaded inserts can be damaged.

Installation Manual Page - 5 -