BatteryShip.com
PLEASE NOTE: Patience and care, along with moderate technical and hand tool ability, are required for the successful replacement of a Clie battery. Excessive force may result in damage to your PDA. The instructions below come with no warranty or guarantee. By utilizing these instructions, you agree to hold Batteryship.com blameless and unaccountable for any and all damages, problems, or personal injuries that may or may not arise by your use of these instructions. Replacing your Clie battery may void any warranty you have on your Clie. Please read all instructions and back up
your data BEFORE replacing the battery.
If your Clie is a different model number, use these instructions as a reference and consult your owner’s manual or a technician if necessary.
Included Mini Flathead Screwdriver | Included Plastic Flathead Screwdriver |
Step 1. | Step 2. |
Remove the two “Y Head” three pointed screws below the label on the back of the device, as shown, using the included mini flathead screwdriver. (Your tools may look different than the picture shown.) You can also use a “Y Head” screwdriver if you have one. Set the screws aside for reassembly.
Remove the two Phillips screws from the upper sides of the device, as shown, using the same mini flathead screwdriver or a 000 Phillips screwdriver. Set the screws aside for reassembly.
Step 3. | Step 4. |
Use the plastic flathead screwdriver or any small flathead screwdriver (plastic recommended - metal may scratch) to separate the back case from the front by CAREFULLY prying around the device. There are clips on all sides of the device holding the front and back together. Be careful not to break them when prying.
Lift off the back cover. Remove ONLY the Phillips screw shown in the picture above, then fold back the protective copper foil (taking care not to tear or damage it) so that the battery can be reached. Set the screw aside for reassembly.
(Steps 5 and 6 Continued on Back)
