AC and DC Side Panels
The DC side of the Freedom SW 3000 has the equipment ground lug, the positive (+) battery terminal, and the negative
Freedom SW 3000 Inverter/Charger Features
Item | Description |
1 | Remote (REM) jack provides connection for the |
| Freedom Sine Wave remote panel (supplied). |
2 | Battery temperature sensor (BTS) jack provides |
| connection for the battery temperature sensor (supplied). |
|
|
3 | Negative |
1 2
REM BTS
3
WARNING: INCORRECT BATTERY OP 
AL TIR YW LIL
CAUSE DAMAGE TO UNIT.
5
INVERTER AC OUTPUT | LINE 1 | AC INPUT |
| LINE 2 | AC INPUT |
Wiring box cover must be in place during use to reduce risk of injury to persons
AC
IN
| battery cable (black). Install a DC terminal cover |
| (supplied) over the terminal. |
4 | Positive (+) DC terminal connects to the positive battery |
| cable (red). Install a DC terminal cover (supplied) over |
| the terminal. |
|
|
5 | AC Input 1, AC Input 2, and Inverter AC Output |
| circuit breaker switches allow you to reset the circuit |
| breakers when they trip. |
|
|
6 | AC knockouts provide access for AC cables (both input |
AC
OUT
AC GROUNDS
(BEHIND COVER)
4 | 9 | 8 | 7 | 6 |
Figure 5 AC and DC Side Panel
| and output wiring). Detach the knockout covers and |
| install the |
7 | AC Output terminal block is a |
| block for attaching AC output wires. Each slot is labeled |
| N1 for Neutral 1, L1 and L2 for Lines 1 and 2, and N2 for |
| Neutral 2. |
|
|
8 | AC Input terminal block is a |
| for attaching AC input wires. Each slot is labeled |
| N for Neutral and L1 and L2 for Lines 1 and 2. |
|
|
9 | Chassis ground lug connects the chassis of the FSW3000 |
| to your system’s chassis grounding point. |
Not | All Ground terminals are along the tab at the bottom of |
shown | the opening to the AC wiring compartment access panel. |
9 |
