Getting Started
Connecting the Turntables to the Mixer
Use the supplied audio cords (with ground wire) to connect the turntables to the mixer’s
1On each turntable, connect the red plug of an audio cord to the R output jack, the white plug to the L output jack, and the ground wire to I (ground) terminal, as shown below.
Turntable2On the mixer, connect the red plugs and white plugs on the other end of each audio cord to the PHONO R and PHONO L INPUT jacks, respectively, for
LINE2 PHONO2 | LINE1 PHONO1 |
L | L |
R | R |
3Connect the ground wires to U (ground) terminal on the mixer.
Mixer
NoteBe sure to connect the ground wire. Failure to do so will cause a humming noise in the turntable.
Connecting an external signal source
To connect a stereo component system with a DJ mixer connector, do the following:
1Remove the jumpers from your stereo component system.
2Use the supplied audio cord (without ground wire) to connect the SEND jack on the stereo component system to the LINE 1 or LINE 2 INPUT jack on the mixer.
Stereo component |
| Mixer |
system |
| |
DJ MIX |
| |
| LINE1 PHONO1 | |
RETURN | l | L |
SEND |
| R |
R L
l: Signal flow3Use the other supplied audio cord (without ground wire) to connect the LINE OUTPUT jack on the mixer to the RETURN jack on the stereo component system.
Mixer |
| Stereo component | ||
OUTPUT | l | system |
| |
| DJ MIX | |||
REC | LINE |
| ||
|
|
|
| RETURN |
|
|
|
| SEND |
|
|
| R | L |
l: | Signal flow |
|
|
|
To connect a stereo component system without a DJ mixer connector or an amplifier, do the following:
1Use the supplied audio cord (without ground wire) to connect the LINE OUTPUT jacks on the mixer to the input jacks on the stereo component system or to the LINE or AUX input jacks on the amplifier.
Mixer | Stereo component | |
|
| |
OUTPUT | system or Amplifier | |
REC | LINE | l |
|
| |
|
| L |
|
| R |
l: | Signal flow | LINE or AUX input jacks |
|
Connecting the AC power cord
After connecting all units, connect the AC power cord from each turntable to an AC wall outlet.
to the AC~INto a wall outletConnect the AC power adaptor cord to the rear of the mixer and the AC power cord from the adaptor to an AC wall outlet.
to theADAPTER DC 15V INto a wall outlet
5