Saving and Loading Lens Files
164
Chapter 7 Saving and Loading User Setting Data
Use FILE >Lens (see page153) in the setup menu
to set the data in lens files.
You can set the following data and save it as a
lens file.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
To save a lens file to an SxS memory card, insert
the card into a memory card slot and then proceed
as follows.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
1Select FILE >Lens in the setup menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see “To assign names to files”
(page161).
2Select Lens Store Mem >Execute (if you
want to save the data in the camcorder’s
internal memory), and select Lens Store
SxS >Execute (if you want to save the
data on an SxS memory card).
3Press the MENU knob.
If you select [Execute], a list box of lens file
number appears. File numbers where “No
File” is displayed are empty file numbers.
4Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Lens Store SxS >Execute in
step2, the ACCESS lamp lights (in blue on
the right-side panel and in orange in the card
slot section) when you execute the save.
When the data has been saved, a completion
message appears and the ACCESS lamp goes
out.
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page73) to the ex ternal device connector.
Select Lens Store USB >Execute in step 2.
To load a lens file from an SxS memory card,
insert the SxS memory card into a memory card
slot, and then proceed as follows.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
1Select FILE >Lens in the setup menu.
2Select Lens Recall Mem >Execute (if
you want to load the file from the
camcorder’s internal memory), and
select Lens Recall SxS >Execute (if you
want to load the file from an SxS
memory card).
3Press the MENU knob.
If you select [Execute], a list box of lens files
appears. File numbers where “No File” is
displayed are empty file numbers.
Saving and Loading Lens Files

Setting Lens File Data

Setting data Sub-items
V modulation shading
compensation values
M V Modulation
Center marker position Lens Center H
Lens Center V
Flare level Lens R Flare
Lens G Flare
Lens B Flare
White balance
compensation value
Lens W-R Offset
Lens W-B Offset
White shading
compensation value
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para

Saving Lens Files

Loading Lens Files