Marking Track Numbers

While Recording

You can mark track numbers either manually or automatically. By marking track numbers at specific points, you can quickly locate the points later using the AMS Function or Editing Functions.

When using the remote, set SELECT to CDR.

REC z

SELECT

REC z

Marking track numbers manually

You can mark track numbers at any time while recording.

Press REC zat the point you want to add a track mark while recording.

Notes

You cannot mark track numbers manually during Synchro-Recording.

Track length must be at least 4 seconds to mark track numbers manually.

Marking track numbers automatically (Track Marking Function)

The unit adds track marks differently in the following cases:

When you make a Synchro-Recording (page 18)

The unit marks track numbers automatically under the control of DECK A.

When recording from a CD or MD connected through the DIGITAL OPTICAL IN jack (with “OPTICAL” selected by the INPUT button)

The unit marks track numbers automatically according to the information contained in the source being recorded. However, the unit may not automatically mark track numbers when recording from some CD players and multi disc players.

In all other cases

When “Track Mark” is set to “LSync” in Setup Menu, the unit marks a new track number whenever the signal drops to the specified level* or below for about 1.5 seconds or longer, then rises to a specified level.

*The initial setting is –50 dB.

To turn off the Track Mark Function

While the unit is stopped, set “Track Mark” in Setup Menu to “Off.” For details, see “Using the Setup Menu” (page 28).

To change the trigger level for Track Marking Function

While the unit is stopped, select “LSync Lvl” in Setup Menu and set the level between

–72 dB and –20 dB. For details, see “Using the Setup Menu” (page 28).

22