101
Additional Information
The sound is breaking up.
,The signal strength is low. For digital
broadcasting, you can check the signal
strength using the blue button (“Signal”) in
“Digital Channel List” in the “Channel”
setup (page85).
,Check aerial installation.
Recording to a DVD is not possible.
,The recording destination is HDD only.
The programme position cannot be
changed from the programme position
you are recording.
,Set the TV’s input source to “TV.”
Recording does not start immediately
after you press zREC.
,Operate the recorder only after
“LOADING,” “FORMATTING,” or
“INFO WRITE” disappears from the front
panel display.
Nothing was recorded even though you
set the timer setting correctly.
,There was a power failure during
recording.
,The recorder’s internal clock stopped due
to a power failure that lasted for more than
30 minutes. Reset the clock (page 83).
,The channel was disabled or erased after
the timer recording was set. See “Digital
Channel List” (page85) a nd “Analog
Manual Setting” (page 85).
,Disconnect the mains lead from the mains,
and connect it again.
,The programme contains copy protection
signals (pay-per-view, AVC) that restrict
copying, or a scrambled channel is
selected.
,A programme with parental control
information has been set for recording. If
the display for entering your password
appears before recording starts, enter your
four-digit password using the number
buttons. Your password is required when
you record programmes with an age limit
that exceeds the age limit you set
(page96).
,Another timer setting overlapped the timer
setting (page43, 52). Check the timer
settings in the schedule list (page 42) and
the Timer List (page52).
,There is not enough disc space for the
recording.
,The recorder was in the process of
dubbing.
Recording does not stop immediately
after you press xREC STOP.
,It will take a few seconds for the recorder
to input disc data before recording can
stop.
Recording does not stop after you press
x.
,Press xREC STOP.
Timer recording is not complete or did
not start from the beginning.
,There was a power failure during
recording. If the power recovers when
there is a timer recording, the recorder
resumes recording.
Should the power failure continue for more
than 30 minutes, reset the clock (page 83).
,Another timer setting overlapped the timer
setting (page43, 52). Check the timer
settings in the schedule list (page 42) and
the Timer List (page52).
,Disc space was not sufficient.
Contents previously recorded were
erased.
,Data that is not playable on this recorder
but was recorded on a DVD with a PC will
be erased from the disc when the disc is
inserted.
Recording/Timer recording/Editing
,continued