,The remote’s manufacturer code returned to the default setting when you replaced the batteries. Reset the code (page 21).

,The remote is not pointed at the remote sensor on the recorder.

The disc tray does not open and “TRAYLOCKED” appears in the front panel display.

,Contact your Sony dealer or local authorized Sony service facility.

OthersThe recorder does not detect a USB device connected to the recorder.

,Make sure that the USB device is securely connected to the recorder (page 106).

,Check if the USB device or a cable is damaged.

,Check if the USB device is on.

Display language on the screen switches automatically.

,When “HDMI Control” is set to “On” in the “HDMI Output” setup (page 125), the display language on the screen automatically switches, according to the language setting of the connected TV, if you change the language settings on your TV, etc.

The recorder does not operate properly.

,Press down [/1 on the recorder for more than five seconds until the recorder turns off. Then, press [/1 again to turn on the recorder.

,When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder and wait until the clock appears in the front panel display. Then, unplug the recorder and after leaving it off for a while, plug it in again.

The disc tray does not open after you press

Z(open/close).

,It may take a few seconds for the disc tray to open after you have recorded or edited a DVD. This is because the recorder is adding disc data to the disc.

Any buttons do not function and “LOCKED” appears in the front panel display.

,The recorder is locked. Cancel the Child Lock (page 61, 88).

“REPAIR” appears in the front panel display.

,The recorder’s repair function is activated to repair the hard disk drive or disc when the recorder is turned on after a power failure has occurred during recorder operation, such as while recording, or when some errors have occurred. Leave the recorder on until “REPAIR” disappears from the front panel display.

“E01” appears in the front panel display.

,There is a problem in the HDD. Contact your nearest Sony dealer. Note that contents on the HDD may be erased when servicing this unit.

“E02” appears in the front panel display.

,A hard disk error has occurred and you cannot make a new recording to the HDD. Press and hold [/1 on the recorder for more than five seconds to turn the recorder off, then turn it on again. If “E02” still appears, format the HDD following the instructions of “Format HDD.” (page 108). Note that all of the recorded contents on the HDD will be erased. If this does not fix the problem, contact your nearest Sony dealer.

“HDCP_ERR” appears in the front panel display.

,The recorder is connected to an input device that is not HDCP compliant. Connect the equipment that is HDCP compliant (page 16).

Disregard this error message if the output picture is displayed correctly.

Mechanical sounds are heard when the recorder is off.

,While the recorder is adjusting the clock for the Auto Clock Set function or updating the EPG information, operational noises may be heard, even when the power is off. This is not a malfunction.

134