Learning the commands of your components
By using the Learning function, it is possible for this remote to perform learned commands.
Setting remote control codes that are not stored in the remote
When a remote control code is not one of the presets stored in the remote, it is possible for the remote to learn the code using the Learning function.
1 Press TV ?/1 while holding down USE
MODE.
The USE MODE button lights and “LEARN” appears in the display.
2 Move the easy scroll key to select the input you want to learn commands for, then press the key to enter the selection.
For example, if you are going to learn an operation for a CD player, select CD/ SACD.
You can also select the TV ?/1 button.
3 Press the button you want to use for the Learning function.
The USE MODE button turns off while a valid button is pressed, then blinks slowly.
4 Point the remote control code receiver section of the remote towards the receiver/transmitter on the remote control to be learned.
5 Press the appropriate button on the remote control to be learned to send the remote button code.
Lightly pressing the button once should be sufficient.
If learning is completed successfully, the USE MODE button slowly flashes twice
and the remote automatically exits the learning mode.
When learning is not completed successfully, the USE MODE button flashes 4 times in quick succession and the procedure returns to step 5.
If the memory of the remote is already full, the USE MODE button flashes 8 times in quick succession and the remote automatically exits the learning mode.
Notes
•You can program at the most 80 keys for the Learning function. In some cases, you may not be able to program even if you have not programmed 80 buttons.
•In steps 2 and 3, the USE MODE button turns off while a valid button is pressed.
•In step 3, if several buttons that can be used for learning are pressed, only the last pressed button is valid. The USE MODE button blinks slowly, then lights when the valid button is selected.
•In step 5, if a button that can be used for learning is pressed, the new button is selected and the learning procedure returns to the beginning of step 5.
To cancel learning
Press USE MODE during any step. The remote automatically exits the learning mode.
To clear the learned codes
Start again from step 1.
After step 3, press TV ?/1 for more than 2 seconds. The USE MODE button blinks twice slowly and the learned code is cleared.
If TV ?/1 is pressed less than 2 seconds, the learning procedure returns to the beginning of step 5.
When a learned code is cleared, if the button was previously programmed for another input, the programmed code for that input can be used.
To use the learned input
Move the easy scroll key to select the learned input, then press the key to enter the selection.
To use a command that has been learned
Select a learned input, then press the learned button for that input.