For accurate learning

•Do not move the remote units during the learning procedure.

•Be sure to keep holding down the button of the other remote control until you hear the confirmation beep.

•Use fresh batteries in both remote control units.

•Avoid learning in places under direct sunlight or strong fluorescent light.

•The remote control detector area may differ depending on each remote unit. If learning does not work, try changing the positions of the two remote control units.

•When you teach signals of an interactive signal exchange system remote control unit (supplied with some of Sony’s receivers and amplifiers) to the Commander, the response signal of the main unit may interfere with the learning of the Commander. In such a case, move to a place where the signals will not reach the main unit (e.g. other rooms, etc.).

IMPORTANT

Be sure to place the Commander out of the reach of small children or pets.

Also set the Hold function to lock all the buttons on the Commander (page 62) when it is not used. Components such as air conditioners, heaters, electric appliances, and electric shutters or curtains receiving an infrared signal can be dangerous if misused.

Changing or erasing the function of a taught label or button

To change the learned function, clear it first and perform learning again.

To clear the learned function of a label or button

After Step 4 (page 24), while pressing the button or the Label Select button corresponding to the label that you want to erase, press the SCROLL button.

“CLEAR OK” appears and the learned function is cleared with a beep sound.

The cleared label flashes together with other learnable labels.

If the character contents of the label have been changed

To clear the character contents of that label, perform the same procedure above again. The input contents are cleared and the label display returns to the original setting.

29