Symptom
“NG” flashes twice.
Remedy
•Learned signals or the Channel Macro function have been programmed for the component label to which you want to copy the settings of another component label using the copying function (page 46). Clear the contents (page 19, 29) and try the copying procedure again.
•You may try to program the
The ‘NG’ sound is heard twice.
“NG” appears during learning.
“NG” appears if you try to copy the settings of the component label to another component label.
A system control program does not function correctly.
•Learned signals have been programmed for the label to which you want to set the learning, Channel Macro or component macro function. Clear the learned signals (page 19, 29) and try setting again.
•You may select the component name for which the Channel Macro function cannot be programmed. You can program the Channel Macro function of the components of which the first digit of the
•You may select the component function label for which the Channel Macro function cannot be programmed. The learned signal or the Channel Macro function have been programmed for that label. Clear the learned signal (page 29) or the Channel Macro function (page 50).
•The program contents you want to change are set to be executed by the timer. Set the timer setting in which that program is included not to be executed (page 58), and edit the program contents.
•You may try to operate the preset function (page 13) after operating the learning function (page 23). You cannot operate the preset function after operating the learning function. Preset after clearing the learned signals (page 29), or preset to another component label key that is not used.
•The memory is full. Clear infrequently used learned labels (page 29), then carry out learning operations.
•There are some function labels for the component for which learned signals have been programmed. Copy the settings to another component label, or clear the learned signals (page 29).
•Make sure that you have programmed the commands in the correct order (page 34).
•Try changing the orientation of the Commander. If that does not help, try placing the components as close to each other as possible.
•Check the status of the components and make sure that you have set the components properly to receive commands (page 38).
•The component codes are changed or new signals have been learned for a label that has been programmed with a series of commands. In this case, the new signals are transmitted when the series of commands is executed.
•The interval may be too short. See “Changing the interval between operation steps” (page 42) and set a longer interval, or adjust the series of commands by changing the order of buttons and labels. (When programming the system control function, you can make an interval by pressing the TIMER button.)
72