ing is not specifically displayed by the mecablitz.
The mecablitz will not fire a pre-flash when:
The reflector is swivelled out of its normal
position.
Second-curtain synchronisation has been set
(REAR mode).
The secondary reflector of the mecablitz has
been switched on.
The camera operates with mirror lock-up.
In this instance the mecablitz will operate with
normal TTL flash control.
To ensure proper operation of multi-zone flash
exposure metering with the above cameras no
filter attachments (e.g. neutral density or
colour effects filters), diffusers (bouncers) etc.
must be mounted in front of the reflector.The
wide-angle diffuser (20mm) integrated in the
mecablitz must not be swivelled in front of the
reflector.Multi-zone flash exposure metering
must be deactivated if any of the aforemen-
tioned attachments are to be used. For this
purpose it will be sufficient to switch the
mecablitz from TTL-HSS mode to TTL mode
(see Section 4.13.2 or refer to the camera’s
operating instructions).
4.18.2 Dimage A1, A2,5, 7, 7i, 7Hi
For system-induced reasons TTL pre-flash
metering with the above digital cameras is
possible with the following flash units: meca-
blitz 32 Z-2, 32 MZ-3, 40 MZ-1, 1i, 3, 3i,
☞
☞
☞
46
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 46