Trouble symptoms and remedies
If a problem occurs as a result of a connected computer or other equipment, refer to the connected computer/equipment’s instruction manual. Use the
For further information and troubleshooting assistance, please visit Sony support website at: http://www.sony.net/
Symptom | Check these items | |
No picture |
| |
|
|
|
| If the 1 (power) indicator is not lit, | • Check that the power cord is properly connected. |
| or if the 1 (power) indicator will not | • Check that the monitor’s MAIN POWER switch is on (page 9). |
| light up when the 1 (power) switch |
|
| is pressed, |
|
|
|
|
| If the 1 (power) indicator turns on | • Check that the 1 (power) switch is on. |
| in red, |
|
|
|
|
| If the 1 (power) indicator is green, | • Use the |
|
|
|
| If “CABLE DISCONNECTED” | • Check that the video signal cable is properly connected and all plugs are firmly seated in |
| appears on the screen, | their sockets (page 7). |
|
| • Check that the video input connector’s pins are not bent or pushed in. |
|
| • Check that the input select setting is correct (page 11). |
|
| • A |
|
| signal cable, “CABLE DISCONNECTED” may appear on the screen. This is not a |
|
| malfunction. |
|
|
|
| If “NO INPUT SIGNAL” appears on | • Check that the video signal cable is properly connected and all plugs are firmly seated in |
| the screen, or the 1 (power) | their sockets (page 7). |
| indicator is amber, | • Check that the video input connector’s pins are not bent or pushed in. |
|
| • Check that the input select setting is correct (page 11). |
|
| xProblem caused by a connected computer or other equipment, and not |
|
| caused by the monitor |
|
| • The computer is in the power saving mode. Try pressing any key on the keyboard or |
|
| moving the mouse. |
|
| • Check that your graphics board is installed properly. |
|
| • Check that the computer’s power is on. |
|
|
|
| If “OUT OF RANGE” appears on | xProblem caused by a connected computer or other equipment, and not |
| the screen (page 20), | caused by the monitor |
|
| • Check that the video frequency range is within that specified for the monitor. If you |
|
| replaced an old monitor with this monitor, reconnect the old monitor and adjust the |
|
| computer’s graphics board within the following ranges: |
|
| Horizontal frequency: |
|
| Vertical frequency: |
|
| Resolution: 1024 ⋅ 768 or less |
|
|
|
| If using Windows, | • If you replaced an old monitor with this monitor, reconnect the old monitor and do the |
|
| following. Select “SONY” from the “Manufacturers” list and select |
|
| X73 or |
|
| |
|
| Play.” |
|
|
|
| If using a Macintosh system, | • When connecting a Macintosh computer, use an adapter (not supplied) if necessary. |
|
| Connect the adapter to the computer before connecting the video signal cable. |
|
|
|
GB
(continued)
21