To cancel searching
Press HPLAY or xSTOP.
To turn off the bar indication
Press DISPLAY again.
Notes
•The figure on the bar indication represents the total time length of the inserted tape as shown below.
The total time length may not be displayed correctly for:
–Tapes other than
–Tapes recorded in more than one tape speed mode.
Tape type | Total time length | ||
|
|
| |
| SP | LP | EP |
|
|
|
|
60 | 120 | 180 | |
|
|
|
|
from | 120 | 240 | 360 |
|
|
|
|
160 | 320 | 480 | |
|
|
|
|
•If you move the pointer (V) on the bar indication while searching, the VCR searches for the new reset point.
•With the bar indication on, the M FF/ , and m REW/ < buttons on the remote commander work only for moving the pointer (V) and are not used for normal tape operation. The M FF and m REW buttons on the VCR are used for normal tape operation. Note, however, if you press these buttons on the VCR, searching is canceled.
86Searching for a selected point on the tape