1.2 INPUT Screen

You can set parameters of the input block of the SRP-X700P from the INPUT screen.

1.2.1 INPUT OVERVIEW Screen

This screen corresponds to the input module of the audio mixer. This screen enables you to set the following.

4 5 qh

1

3

2

6

qk

7

8q;

9

qa

qs

qf

qd qj

qg

1INPUT index

Displays the index that is input on the BLOCK screen.

2INPUT level meter

Displays the input signal level after the TRIM adjustment is complete with the VU response.

3+48 V indicator

The +48 V indicator lights in red when the +48 V button on the rear of the SRP-X700P is turned on.

4RF indicator

The RF indicator lights in green when the wireless tuner unit installed in the SRP-X700P receives the RF signal. As long as this indicator is on, this system selects the wireless tuner signal.

5LINE indicator

The LINE indicator lights in green when the MIC/LINE select button on the rear of the SRP-X700P is set to the LINE position.

6TRIM controls

The TRIM controls enable you to adjust the reference input level of each input channel.

Each click of the [+] or [--]button increments or decrements the reference input level by 1 dB. The adjustment range of MIC1/ WL1, MIC2/WL2, MIC3 and MIC4 is –60 dBu to –45 dBu. The adjustment range of LINE3 and LINE4 is –10 dBu to 0 dBu. The adjustment range of MIC5/LINE1 and MIC6/LINE2 is

–60 dBu to –45 dBu when MIC is selected or –10 dBu to +5 dBu when LINE is selected. You can also enter numerical values directly.

It is recommended to adjust the TRIM controls so that 0 VU of the INPUT level meter lights often.

7Setup.. button

By clicking the Setup button, the display jumps to the INPUT EQ screen where you can set the low-cut filter, feedback reducer and parametric equalizer.

8LCF (Low-Cut Filter) button

Each press of this button toggles the low-cut filter between on and off. This button lights in green when pressed on. The LCF removes low-frequency components such as blowing noise and makes the sound clear.

9PEQ (Parametric Equalizer) button

Each press of this button toggles the parametric equalizer between on and off. This button lights in green when pressed on. To set the PEQ, click on the 7 Setup.. button.

0FR (Feedback Reducer) button

Each press of this button toggles the feedback reducer that is set on the INPUT EQ screen between on and off. This button lights in green when pressed on. To set the FR, click on the

7Setup.. button.

qa COMP (Compressor) setup box

This function compresses the dynamic range of the input signal that affects the unity sound volume. The compressor can be set in three steps of SOFT, MID or HARD.

When the AUTOMATIC MIXER is turned ON, the compressor is set automatically and the manual COMP setup is disabled.

qs MUTING button

Pressing this button mutes the input signal of each channel. The MUTING button lights in red when muted.

9