Setup
15
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is shown
below:
Figure 5: LAN Screen

Data - LAN Screen

TCP/IP
IP Address IP address for the Wireless DSL/Cable Router, as seen from the local
LAN. Use the default value unless the address is already in use or your
LAN is using a different IP address range. In the latter case, enter an
unused IP Address from within the range used by your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the DSL/Cable Router is attached (the same value as
the PCs on that LAN segment).
DHCP Server • If Enabled, the DSL/Cable Router will allocate IP Addresses to
PCs (DHCP clients) on your LAN when they start up. The default
(and recommended) value is Enabled.
• If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-configured to
treat the DSL/Cable Router as the Gateway. See the following sec-
tion for further details.
• The Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Buttons
Save Save the data on screen.
Cancel The "Cancel" button will discard any data you have entered and reload
the file from the DSL/Cable Router.