If there is a malfunction, the display shows a code of two numbers and a message. You can check the condition of the system by the message. Refer to the following table to solve the problem. If any problem persists, consult your nearest Sony dealer.
DEC. ERORAppears when the signal which the receiver cannot decode (ex.
Irregular current is output from the speakers. Turn off the receiver, check the speaker connection and turn on the power again. If this problem persists, turn off the receiver and consult your nearest Sony dealer.
Reference sections for clearing the memoryTo clear | See |
All memorized settings | |
|
|
Customized sound fields | |
|
|
Specifications
AUDIO POWER SPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTION:
(Models of area code U only)
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output.
Amplifier sectionPOWER OUTPUT
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%) 100 W + 100 W (4 ohms 20 Hz – 20 kHz, THD 0.09%) 80 W + 80 W Reference Power Output
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT1): 100 W + 100 W
CENTER1): 100 W
SURR1): 100 W + 100 W SURR BACK1):
100 W + 100 W
(4 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT1): 80 W + 80 W
CENTER1): 80 W
SURR1): 80 W + 80 W SURR BACK1):
80 W + 80 W
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7%) | 100 W + 100 W2) |
| 90 W + 90 W3) |
(4 ohms 1 kHz, THD 0.7%) | 90 W + 90 W2) |
| 80 W + 80 W3) |
Reference Power Output2) (8 ohms 1 kHz, THD 0.7%)
FRONT1): 100 W + 100 W
CENTER1): 100 W
SURR1): 100 W + 100 W
SURR BACK1): 100 W
(4 ohms 1 kHz, THD 0.7%)
FRONT1): 90 W + 90 W
CENTER1): 90 W
SURR1): 90 W + 90 W
SURR BACK1): 90 W
(8 ohms 20 Hz – 20 kHz, THD 0.09%)
FRONT1): 90 W + 90 W
CENTER1): 90 W
SURR1): 90 W + 90 W
SURR BACK1): 90 W
(4 ohms 20 Hz – 20 kHz, THD 0.09%)
continued
Information Additional