• AUTO
When a DTS 96/24 signal is input, it is played back at 96 kHz sampling frequencies.
• OFF
Even when a DTS 96/24 signal is input, it is played back at 48 kHz sampling frequencies.
Note
This parameter is valid only in the A.F.D. mode (page 33). In other sound fields, this parameter is always set to “OFF”.
x SB DECODING
(Surround back decoding mode)
You can use the CUSTOMIZE menu to set the surround back decoding mode. See page 36.
• AUTO
• MATRIX
• OFF
DTS 96/24 DEC. (DTS 96/24 decoding mode)
x
• ON
The advanced parameters for the SPEAKER SET UP, SURR SET UP and LEVEL menus are displayed and can be adjusted.
For details on each setup item, see pages 19, 39, 40 and the following pages.
• OFF
The advanced parameters are not displayed.
MENU EXPAND (Menu expanding)
x
3 Rotate –/+ to adjust the selected parameter.
4 Repeat steps 2 and 3 to adjust the other items.
CUSTOMIZE menu parameters The initial setting is underlined.
Rotate MAIN MENU to select “CUSTOMIZE”.
Rotate MENU to select the parameter.
1
2
Advanced settings
Using the CUSTOMIZE menu to adjust the receiver
You can adjust various receiver settings using the CUSTOMIZE menu.

xCENTER MID XXX Hz

(Center speaker midrange frequency)

Initial setting: 1 kHz

You can adjust from 100 Hz to 10 kHz in 5 steps (100 Hz, 300 Hz, 1 kHz, 3 kHz, 10 kHz).

xCENTER TREBLE XXX dB (Center speaker treble level)

xSURR/SB BASS XXX dB (Surround/surround back speaker bass level)

xSURR/SB TRE. XXX dB (Surround/surround back speaker treble level)

Initial setting: 0 dB

You can adjust from –10 dB to +10 dB in 1 dB steps.

xPRESET X CLEAR (Equalizer bank clear)

You can reset the adjusted equalizer settings to the initial setting. For details, see “Clearing stored equalizer settings”.

Tip

You can adjust the front speaker bass and treble level with BASS control and TREBLE control.

To apply the stored equalizer

1Rotate MAIN MENU to select “EQUALIZER”

2Rotate MENU to select “EQ PRESET”.

3Rotate –/+ to select “EQ PRESET [1] – [5]”.

Clearing stored equalizer settings1 Rotate MAIN MENU to select “EQUALIZER”.

2

3

Rotate MENU to select “EQ PRESET”.Rotate +/– to select the equalizer (EQ PRESET [1] – [5]) you want to clear.

4

5

Rotate MENU to select “PRESET X CLEAR”.

“X” is the number of the selected equalizer bank.

Rotate –/+ to select “YES”, then pressMEMORY/ENTER.

“Are you sure?” appears in the display.

6 Rotate –/+ to select “YES”, then press

MEMORY/ENTER.

“PRESET X CLEARED!” appears in the display and the adjusted contents of the selected equalizer bank are cleared.

42GB