Press TUNER.
The last received station is tuned in.
Presetting radio stations

1

2 Tune in the station that you want to preset using Direct Tuning (page 13) or Automatic Tuning (page 14).

3 Press MEMORY/ENTER.“MEMORY” appears in the display for a few seconds.Do steps 4 to 6 before “MEMORY” goes out.4 Press SHIFT to select a memory page (A, B or C).Each time you press SHIFT, the letter “A”, “B”, or “C” appears in the display.5 Press the numeric buttons to select a preset number.If “MEMORY” goes out before you press the preset number, start again from step 3.6 Repeat steps 2 to 5 to preset another station.To change a preset number to another stationDo steps 1 to 5 to preset a new station to the number.

Note

If the AC power cord is disconnected for about one week, the preset stations will be cleared from the receiver’s memory, and you will have to preset the stations again.

Tuning to preset stationsYou can tune the preset stations by either of the following two ways.Scanning the preset stations

1 Press TUNER.

The last received station is tuned in.

2 Press PRESET TUNING +* or PRESETTUNING –* repeatedly to select the preset station you want.

Each time you press the button, the receiver tunes in one preset station at a time, in the corresponding order and direction as follows:

nA1˜A2˜...˜A0˜B1˜B2˜...˜B0NnC0˜...C2˜C1N*For models of area code CEL, CEK: PRESET/PTY SELECT + or PRESET/PTY SELECT – .Using the preset codes

You can tune directly to a preset station by entering its preset number on the receiver or the supplied remote.

1 Press TUNER.

The last received station is tuned in.

2 Press SHIFT to select a memory page (A, B, or C), then press the preset number of the station you want using the numeric buttons.

Broadcasts Receiving

15GB