Troubleshooting (continued)

The remote does not function.

•Point the remote at the remote sensor g on the receiver.

•Remove any obstacles in the path between the remote and the receiver.

•Replace both batteries in the remote with new ones, if they are weak.

•Make sure you select the correct function on the remote.

•If the remote is set to operate the TV only, use the remote to select a source or component other than TV before operating the receiver or other component.

Clearing the receiver’s memory

To clear

See

All memorized settings

page 11

 

 

Specifications

AUDIO POWER SPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTION:

With 8 ohm loads, both channels driven, from 40 – 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than

0.09% total harmonic distortion from 250 milliwatts to rated output (Models of area code U only).

Amplifier sectionPOWER OUTPUT Models of area code URated Power Output at Stereo Mode (8 ohms 40 Hz – 20 kHz, THD 0.09 %)

100 W + 100 W

Models of area code CEL, CEK Rated Power Output at Stereo Mode

(8 ohms 1 kHz, THD 0.7 %)

100 W + 100 W1)

1) Measured under the following conditions:

 

Area code

Power requirements

 

CEL, CEK

230 V AC, 50 Hz

 

 

 

Frequency response

 

CD, MD/TAPE,

20 Hz – 50 kHz

VIDEO 1, VIDEO 2

+0/–0.5 dB (with bass

 

 

boost bypassed)

 

 

Inputs (Analog)

 

CD, MD/TAPE,

Sensitivity: 250 mV

VIDEO 1, VIDEO 2

Impedance: 50 kilohms

 

 

S/N2): 85 dB

 

 

(A, 250 mV3))

2)INPUT SHORT.

3)Weighted network, input level.

Outputs

MD/TAPE, VIDEO 1

Voltage: 250 mV

 

Impedance: 10 kilohms

 

 

Bass Boost:

+8 dB at 70 Hz

Tone:

±10 dB at 100 Hz and

 

10 kHz

22GB