Getting Started
Unpacking
Check that you received the following items with the receiver:
•FM wire antenna (1)
•AM loop antenna (1)
•Remote controller (remote) (1)
•Size AA (R6) batteries (2)
Hookup Overview
The receiver allows you to connect and control the following audio components. Follow the hookup procedures for the components that you want to connect to the receiver on the pages specified. To learn the locations and names of each jack, see “Rear Panel Descriptions” on page 14.
Audio/Video Component
Hookups (5)
Inserting batteries into the remote
Insert two size AA (R6) batteries in accordance with the + and – markings on the battery compartment. When using the remote, point it at the remote sensor g on the receiver.
]
}
}
]
When to replace batteries
Under normal use, the batteries should last for about 6 months. When the remote no longer operates the receiver, replace both batteries with new ones.
Speaker
System
Hookups (6)
Front speaker
(L)
TV tuner
Cable TV
VCR
CD player
Tape/MD deck
Turntable
Antenna Hookups (5)
AM/FM antenna
Front speaker
(R)
Notes
•Do not leave the remote in an extremely hot or humid place.
•Do not use a new battery with an old one.
•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.
•If you don’t use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.
Before you get started
•Turn off the power to all components before making any connections.
•Do not connect the AC power cords until all of the connections are completed.
•Be sure to make connections firmly to avoid hum and noise.
•When connecting an audio cable, be sure to match the
4
