Broadcasts Receiving
Direct Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 37.
1Press TUNER.
The last received station is tuned in.
2Press FM or AM to select the FM or AM band.
3Press D.TUNING on the remote.
4Press the numeric buttons on the remote to enter the frequency.
Example 1: FM 102.50 MHz
1 b 0 b 2 b 5 b 0
Example 2: AM 1350 kHz
(You don’t have to enter the last “0” when the tuning interval is set to 10 kHz)
1 b 3 b 5 b 0
If you cannot tune in a station and the entered numbers flash
Make sure you’ve entered the right frequency. If not, repeat Steps 3 and 4.
If the entered numbers still flash, the frequency is not used in your area.
5If you’ve tuned in an AM station, adjust the direction of the AM loop antenna for optimum reception.
6Repeat Steps 2 to 5 to receive other stations.
zIf you try to enter a frequency not covered by the tuning interval
The entered value is automatically rounded up or down.
Tuning intervals for direct tuning are:
FM: 50 kHz
AM: 10 kHz (to change to 9 kHz, see page 47.)
Automatic Tuning
For details on the buttons used in this section, see “Brief descriptions of buttons used to receive broadcasts” on page 37.
1Press TUNER.
The last received station is tuned in.
2Press FM or AM to select the FM or AM band.
3Press TUNING + or TUNING
Press the + button to scan from low to high; press the – button to scan from high to low.
When the receiver reaches either end of the band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is received.
4To continue scanning, press TUNING + or TUNING – again.
38