English

Before installation

To Customers

For product protection and safety reasons, Sony strongly recommends that wall-mounting of your Display Unit be performed by a reliable licensed contractor. Do not attempt to install it yourself. Your KE-V42A10E/KLV-V40A10E/KLV-S40A10E/ KDL-V40A11E/KDL-S40A11E can be wall- mounted using SU-PW2 Wall-Mount Bracket (sold separately). Please provide your contractor with this installation supplement as well as the Instructions (supplied with SU-PW2 Wall-Mount Bracket). Read these documents carefully for safety and proper installation.

To Sony Dealers and Contractors Provide full attention to safety during the installation, periodic maintenance and examination of this product.

Step 1: Check the parts required for the installation

Open the Wall-Mount Bracket package and check the contents for all required parts along with the Instructions.

Step 2: Decide on the installation location

Decide where you want to install your Display Unit. Turn to the back cover or inside the back cover for the display installation dimensions and determine the location.

If you intend to route the cables in the wall, also determine the position of the cable hole and bore a hole in the wall.

Installing the Display Unit on a wall

The Display Unit can be installed on a wall by attaching a Wall-Mount Bracket (sold separately). Verify your TV’s model number and be sure to use the bracket specified for your model only. Refer to the Steps on this leaflet along with the Instructions supplied with SU-PW2 Wall-Mount Bracket, to properly carry out the installation.

Sufficient expertise is required for installing this product. Be sure to subcontract the installation to Sony dealers or licensed contractors and pay special attention to safety during the installation.

Sony is not liable for any damages or injury caused by mishandling or improper installation. Your Statutory Rights (if any) are not affected.

Hole for cable routing (One of two)

Refer to the Instructions for the SU-PW2.

Step 3: Install the Plate Unit on the wall

Change the position of the Mounting Hook Unit supported shafts.

Refer to the Instructions for the SU-PW2.

2 (GB)