Prepare for the installation of the Display Unit

Before removing the Table-Top Stand, disconnect all the cables from the Display Unit.

Refer to the Instructions for the SU-PW2.

1Place the Display Unit, with its screen facing down, on a stable, cloth-covered work surface, at least 20 cm off the floor.

2Remove the screws that hold the Display Unit to the Table-Top Stand and detach the Table-Top Stand from the Display Unit.

3Remove six screws on the rear side of the Display Unit (for KE-V42A10E only).

GB

4Attach the supplied four hooks with the supplied four screws (+PSW5 ⋅ L16).

Screw into the recessed screw holes.

Note

When using an electric screwdriver, set the torque setting to approximately 2 N·m.

Note

Remove the cable holder beforehand when it is attached to the Display Unit. For details on the cable holder, refer to the instruction manual of the Display Unit (for KE-V42A10E/KLV- V40A10E/KDL-V40A11E only).

Step 4: Install the Display Unit

Refer to the Instructions for the SU-PW2.

(GB) 3