Getting Started
Tape deck, DAT deck, or MD deck
Amplifier | Tape deck | |
TAPE1/DAT | OUTPUT | INPUT |
REC OUT IN | LINE | LINE |
L | Ç | L |
|
| |
R |
| R |
| ç |
|
Use the configuration above to connect the OUTPUT and INPUT jacks of:
Turntable
1Remove the shorting plugs from the PHONO jacks before connecting the cables (but not unless you connect a turntable).
Do not attach the shorting plugs to any set of the REC OUT jacks. Doing so may stop output from the amplifier or cause the unit to malfunction.
2Connect the audio connecting cords.
AmplifierTurntable
PHONO
IN
L 
Ç
R
Note
To prevent hum, connect the earth lead to SIGNAL GND (y) on the amplifier.
TV or video deck
Amplifier |
| TV or video deck |
AUX |
| OUTPUT |
IN | Ç | LINE |
L | L | |
R |
| R |
EON CONTROL
AmplifierTuner
EON CONTROL | Ç | EON CONTROL |
IN |
| OUT |
If your tuner is equipped with an EON CONTROL OUT terminal, connect it to the EON CONTROL IN terminal on the amplifier to allow use of the EON (Enhanced Other Networks) function of the RDS (Radio Data System) (see page 8).
Speaker System Hookups
Overview
Here you learn how to connect speakers to the amplifier. You can connect two pairs of speakers, SPEAKERS A and B
•
| SPEAKERS A | SPEAKERS B | |
INPUT | TAPE1 / DAT |
|
|
R L | R L |
|
|
AUX | REC OUT |
|
|
|
| SPEAKERS | |
CD | IN | + R – | – L + |
TUNER | REC OUT | B |
|
PHONO | IN |
|
|
y | TAPE2 / MD | A |
|
| + R – | – L + | |
|
| ||
•
SPEAKERS
y | SPEAKERS | |
IMPEDANCE USE 4 - 16 Ω | ||
| R | L |
|
|
|
|
| + | + |
PHONO TUNER | CD | AUX | TAPE2 / MD | TAPE1 / DAT |
| |
IN | IN | IN | IN | REC OUT IN | REC OUT IN |
|
L
––
R
•
|
| SPEAKERS |
y |
|
|
PHONO TUNER CD TAPE2 / MD TAPE1 / DAT |
| |
IN IN | IN REC OUT IN REC OUT IN | SPEAKERS |
|
| |
L |
| + R – – L + |
R |
|
|
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+) | (+) |
Twist the stripped ends of the cord about 15mm. Be sure to match the speaker cord to the appropriate terminal on the components: + to + and – to
5EN