Sony TRV315, DCR-TRV203, TRV210, TRV310 (1), (2), [a], (3), [c], (4), (5), [b], (6), Notes, Inserting a scene from a VCR, To change the insert end point, When the inserted picture is played back

Inserting a scene from a VCR

(1)Set the POWER switch to VTR.

(2)On the VCR, locate just before the insert start point [a], then press P to set the VCR to the playback pause mode.

(3)On your camcorder, locate the insert end point [c] by pressing 0or ). Then press P to set it to the playback pause mode.

(4)Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY indicator flashes and the end point of the insert is stored in memory.

(5)On your camcorder, locate the insert start point [b] by pressing 0, then press two r REC buttons at same time to set your camcorder to the recording pause mode.

(6)First press P on the VCR, and after a few seconds press Pon your camcorder to start inserting the new scene.

Inserting automatically stops near the zero point on the tape counter. Your camcorder automatically returns to the recording pause mode.

5 REC

4 ZERO SET	0:00:00
	ZERO SET
MEMORY
	MEMORY

To change the insert end point

Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY indicator and begin from step 3.

Notes

•The zero set memory function works only for tapes recorded in the Digital8 system.

•The picture and sound recorded on the section between the insert start and end points will be erased when you insert the new scene.

When the inserted picture is played back

The picture may be distorted at the end of the inserted section. This is not a malfunction.

To insert a scene without setting the insert end point

Skip step 3 and 4. Press pwhen you want to stop inserting.

Equipment Other on Editing

53