UPA-PC100

English

Addendum for the UPA-PC100

This document provides additional information about specification changes and new features added since the release of Ver. 2.04. Please use this document together with the Ver. 1.00 manuals (User’s Guide and Operating Instructions), and the addendum for Ver. 2.04.

Changes: Ver. 2.04 to Ver. 2.05

The following specifications have been added:

•UP-DR100 Update Function

The firmware of the UP-DR100 printer can be updated to the latest version.

•UY-S100 Compatibility and UY-S90/100 Lookup Table Settings

Compatibility is now provided for Film Scanner UY-S100 with SCSI connection. Further, the UY-S90/100 lookup table can now be selected.

•“Shop staff only” Output Service

The [Shop staff only] output service allows printing several prints of one image together in standard sizes.

•Addition of Currency Unit

A wider variety of currency unit options for charges are displayed on the control screen than were available with the old version. It is also possible to select non-display of the currency unit.

Version Updates

The following notice applies to each FIRMWARE PROGRAM provided by Sony Corporation (hereinafter referred to as Sony). Please read the following notice before upgrading the firmware.

By upgrading the firmware, you accept to the following terms and condition.

•Execute the update procedure carefully. Failure to update the firmware properly could cause the equipment to malfunction.

Sony shall not be liable for any damages or losses caused by a procedural error by the customer during the firmware upgrade.

•Cost to repair damage to the product caused updating the firmware incorrectly shall be borne by the customer, even if the product is still under warranty.

•Sony authorized service facilities provide firmware upgrade assistance on request for a fee. If you require assistance, please contact the dealer where you purchased the product or any Sony authorized service facility.

Changing the UY-S90/100 Lookup Table

The lookup table of the Film Scanner UY-S90/100 connected to the UPA-PC100 can be changed.

The lookup table can be changed on the [Setting – H/W – Scanner – UY-S90/ 100] screen of the Configuration Utility. For details about how to start and end the Configuration Utility, refer to the User’s Guide (separate booklet). For details about the differences in scanned images caused by changing the lookup table, please refer to the instructions provided with the UY-S90/100.

Updating the UP-DR100

This function updates the firmware of the UP-DR100 connected to the UPA-PC100 with the most recent version.

The version update is performed on the Configuration Utility’s [Setting – H/W

–Printer – UP-DR100] screen. For details about how to start and end the Configuration Utility, refer to the User’s Guide (separate booklet).

The lookup table used by the UY-S90/100 is selected from [Photo] and [Publishing]. Touch the [LUT] button to open a screen, touch the button of the desired lookup table, then touch the [OK] button.

Printing a Photo in Standard Sizes

After you touch the [Version Up] button, a message prompts you to confirm that you want to update the UP-DR100 firmware. Touch the [OK] button and then follow the instructions displayed on the screen to perform the procedure.

Note

After the version update is completed, be sure to switch off all UP-DR100s connected to the UPA-PC100 and the UPA-PC100 itself, then switch the equipment on again.

Sony Corporation ©2002

Several prints of one image can be output in standard sizes.

Note

The size of print paper cannot be selected once the procedure has been started. Before beginning this procedure, please select the print paper size with the Configuration Utility. For details about how to change the Configuration Utility settings, please refer to “Changing the Settings” below.

3-206-885-13(1)

1