58
To return the unit to the default condition
When you perform the steps described below, the following items are reset to the factory default
condition.
•Type of Network
•Wireless LAN environment
•IP address
•Music repeat and shuffle settings
•Slide show interval setting (page 76)
•Slide show repeat setting (page 76)
•Display language
1At the ??? “System Setup” ??? screen, use the V/v buttons to select
??? “Factory Default” ???, and press the SELECT button.
The ??? “Factory Default” ??? screen appears.
2Use the V/v/B/b buttons to select “OK”, and press the SELECT button.
All settings return to the factory default condition.
To select the TV type
To select the type of TV connected to the Network Media Receiver, proceed as follows.
1At the ??? “System Setup” ??? screen, use the V/v buttons to select
??? “TV Type” ???, and press the Enter button.
The ??? “TV Type” screen appears.
2Use the V/v buttons to select the type of TV set, and press the Enter
button.
3Use the V/v buttons to select “OK”, and press the Enter button.
Note
If you select the 16:9 high-resolution setting, the screen may go blank with some TV sets. If this happens,
disconnect the power cord, and then reconnect it and turn power on again.