BAdjustments and Settings Using the Menu
Using the MENU

The projector is equipped with an on-screen menu for making various adjustments and settings. You can change the menu language displayed in the on-screen menu.

To change the menu language, see “Selecting the Menu Language” on page 20.

1 Press the MENU key.

The menu appears.

The menu presently selected is shown as a yellow button.

PICTURE CTRL

INPUT-A

 

CONTRAST: 8 0

BRIGHT: 5 0

GAMMA MODE: GRAPHICS

COLOR TEMP: HIGH

2 Use the Mor mkey to select a menu, then press the ,or ENTER key.

The selected menu appears.

Menus

Setting items

SET SETTING

INPUT-A

STATUS: ON

INPUT-A: RGB

KEYSTONE MEMORY: ON

DIGITAL KEYSTONE: OFF

LANGUAGE: ENGLISH

INSTALLATION: FLR-FRONT

POWER SAVING: OFF

SIRCS RECEIVER: FRONT&REAR

LAMP TIMER: 00010h

3 Select an item.Use the Mor mkey to select the item, then press the ,or ENTER key.4 Make the setting or adjustment on an item.

•When changing the adjustment level: To increase the number, press the Mor ,key.

To decrease the number, press the m or < key.

Press the ENTER key to restore the original screen.

•When changing the setting:

Press the M or m key to change the setting.

Press the ENTER or <key to restore the original screen.

To clear the menu

Press the MENU key.

The menu disappears automatically if a key is not pressed for one minute.

To reset items that have been adjusted

Press the RESET key.

“Complete!” appears on the screen and the settings appearing on the screen are reset to their factory preset values.

Items that can be reset are:

•“CONTRAST,” “BRIGHT,” “COLOR,” “HUE,” and “SHARP” in the PICTURE CTRL menu

•“DOT PHASE,” “SIZE,” and “SHIFT” in the INPUT SETTING menu

•“DIGITAL KEYSTONE” in the SET SETTING menu

About the memory of the settings

The settings are automatically stored in the projector memory.

If no signal is input

If there is no input signal, “NO INPUT– Cannot adjust this item.” appears on the screen.

GB 26 Using the MENU