BMaintenance
MaintenanceReplacing the Lamp

When the lamp has burnt out or dims, or “Please replace the LAMP.” appears on the screen, replace the lamp with a new one. Use LMP-C121 Projector Lamp as the replacement lamp. The lamp life varies depending on conditions of use.

When replacing the lamp after using the projector

Turn off the projector, then unplug the power cord.

Wait for at least an hour for the lamp to cool.

Caution

The lamp becomes a high temperature after turning off the projector with the I / 1key. If you touch the lamp, you may scald your finger. When you replace the lamp, wait for at least an hour for the lamp to cool.

1 Place a protective sheet (cloth) beneath the projector. Turn the projector over so you can see its underside.

Note

Be sure that the projector is stable after turning it over.

2 Open the lamp cover by loosening a screw with the Phillips screwdriver (supplied with the Projector Lamp).

Note

For safety sake, do not loosen any other screws.

3 Loosen the screws on the lamp unit with the Phillips screwdriver. Pull out the lamp unit by the handle.

Handle

4 Insert the new lamp all the way in until

Maintenance

it is securely in place. Tighten the

 

screws. Fold up the handle.

 

Notes

•Be careful not to touch the glass surface of the lamp.

•The power will not turn on if the lamp is not secured properly.

5 Close the lamp cover and tighten the screws.6 Turn the projector back over.

Maintenance 29 GB