Setting items | Functions | Initial setting | ||||
|
|
|
|
|
|
|
ID Mode | Assigns an ID number (1 to 3) to the projector when you | All | ||||
| want control two or more projectors individually with the |
| ||||
| supplied Remote Commander. When this item is set to “1,” |
| ||||
| you can control the projector with the Remote Commander |
| ||||
| with the ID MODE key set to “1.” When it is set to “All,” |
| ||||
| you can control all the projectors with the Remote |
| ||||
| Commander independently of the ID MODE keys of the |
| ||||
| Remote Commander. |
| ||||
|
|
|
|
|
|
|
Illumination | Selects whether the SONY logo on the rear panel of the | On | ||||
| projector lights when the projector is on. |
| ||||
|
|
|
|
|
|
|
Direct Power On | Set to “On” if you are using a circuit breaker to turn the | Off | ||||
| power on/off the entire system. You can turn off the power |
| ||||
| just by unplugging the power cord without pressing the ?/1 |
| ||||
| key. |
| ||||
|
|
|
|
|
|
|
Blanking | Adjust the displayable area within the four directions of the | 0 | ||||
| screen. |
| ||||
| Select each screen edge “left / right / up / bottom” on the |
| ||||
| Blanking adjustment screen with M / m key. Adjust the |
| ||||
| desired Blanking value with < / , key. |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Notes
•Depending on the picture position adjusted with the lens shift feature, the aspect ratio of the picture may change from the original or picture distortion may occur with V Keystone adjustment.
•When both Blanking and V Keystone are adjusted at the same time, Blanking may not function properly. When you use Blanking, set the V Keystone to “0.”
•Since the displayable area becomes narrower when Blanking value is adjusted, information necessary on
Menu a Using Settings and Adjustments
The Installation Menu 37