Sony vpl-fw300L Installing the HD-SDI/SDIInput Adaptor, Replacing the Lens, lens, 6 Replace the lens cover, Use both hands to withdraw the lens

6 Replace the lens cover.

Align the two tabs with the slots, place the lens cover over the lens, then tighten the two screws at the bottom.

Tabs

Note

Move the lens fixing lever completely downward. Otherwise you cannot lock the lens.

Replacing the Lens

The procedure for replacing the lens is the same as that for “Attaching a Lens.” Perform steps 1 to 3 to unlock the lens fixing lever, and withdraw the lens straight forward. Then perform steps 4 to 6 to attach another

Installing the HD-SDI/SDI Input Adaptor

You can install the optional BKM-FW16 HD-SDI/SDI Input Adaptor in INPUT E of the connector panel section of the projector.

1 Turn off the power of the projector and disconnect the power cable.

2 Remove the two screws from the blank panel attached to the connector panel section, and remove the blank panel.

INPUT A	RGB
INPUT B	RGB
			INPUT D	HDMI
OUTPUT	MONITOR
R/R-Y/PR	G/Y
		B/B-Y/PB
			HD
				VD
				INPUT C
				INPUT E	Blank panel

3 Insert the BKM-FW16 HD-SDI/SDI Input Adaptor as far as it goes.

lens.

Note

Use both hands to withdraw the lens.

INPUT A	RGB
INPUT B	RGB
			INPUT D	HDMI
OUTPUT	MONITOR
R/R-Y/PR	G/Y
		B/B-Y/PB
			HD
				VD

INPUT C

INPUT E

HDSDI/SDI	AUDIO
	CHANNEL
HDSDI/SDI
INPUT
ADAPTOR

BKM-FW16

HD-SDI/

SDI Input

Adaptor

4 Tighten the two screws on the BKM-FW16.

INPUT A	RGB
INPUT B	RGB
			INPUT D	HDMI
OUTPUT	MONITOR
R/R-Y/PR	G/Y
		B/B-Y/PB
			HD
			VD
				INPUT C
			HDSDI/SDI	INPUT E
				AUDIO
				CHANNEL
		HDSDI/SDI	INPUT
			ADAPTOR

Installing the HD-SDI/SDI Input Adaptor 17