Attaching a Lens

The projector comes from the factory with no lens attached. You can attach the following types of optional lenses to the projector:

•VPLL-Z4019 Standard Zoom Lens

•VPLL-4008 Fixed Short Focus Lens (for rear projection, optical axis angle 0 degrees))

•VPLL-Z4015 Short Focus Zoom Lens•VPLL-Z4025 Middle Focus Zoom Lens•VPLL-Z4045 Long Focus Zoom LensAttaching a LensFollow the steps below to attach a lens:

For details on the lens, also refer to the operating instructions supplied with the lens.

1 Turn off the power of the projector and disconnect the power cable.2 Remove the lens cover.1Remove the lens hole cover.2Loosen the two screws at the bottom.

Lens cover

1

2

3While lifting the lens cover, pull it toward you to remove. (The lens cover is fixed to the projector with two tabs on the top.)

3

3 Move the lens fixing lever upward to unlock.

Lens fixing lever

Note

Move the lens fixing lever completely upward. Otherwise you cannot attach or remove the lens.

4 Remove two lens caps and insert the lens straightwith a white circle mark up, as far as it goes.

White circle mark

Notes

•Attach the lens carefully so as not to damage the lens glass with the lever or other parts.

•If the lens does not go in fully, turn the lens slightly right and left.5 Move the lens fixing lever down to the bottom correctly.The lens is locked.

If the lens fixing lever does not move down, the lens may not be fully inserted. Insert it again and move the lens fixing lever down to the bottom correctly.

16 Attaching a Lens