Sony VPL-HS60 Others, Troubleshooting, Power, Picture

Others

This section describes how to solve the problems, how to replace a lamp and air filter, etc.

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct the problem using the following instructions. If the problem persists, consult with qualified Sony personnel.

Power

Symptom	Cause and Remedy
The power is not turned on.	c Wait for about one minute before turning on the power. (1 page
	25)
	c Close the lamp cover securely. (1 page 48)
	c Close the air filter cover securely. (1 page 49)

Picture

Symptom	Cause and Remedy
No picture.	c Check that the proper connections have been made. (1 page
	13)
	c Select the input source correctly using the INPUT button. (1
	page 24)
	c Set the computer signal to output from an external monitor.
	c Set the computer signal to output only to an external monitor.
	c Select “Computer,” “Component” or “Video GBR” for “Input-A
	Signal Sel.” in the Setup		menu according to the input
	signal. (1 page 42)
The picture from the	c Select “Computer,” “Component” or “Video GBR” for “Input-A
INPUT A connector is	Signal Sel.” in the Setup		menu according to the input
colored strange.	signal. (1 page 42)
The picture from the	c Adjust the picture in the “Adjust Picture” of the Picture
VIDEO or S VIDEO	menu (1 page 37)
INPUT connector is	c Set “Color System” in the Setup			menu to match the color
colored strange.	system being input. (1 page 42)
The picture is too dark.	c Adjust the contrast or brightness in the “Adjust Picture” of the
	Picture	menu properly. (1 page 37)
The picture is not clear.	c Adjust the focus with the focus ring. (1 page 25)
	c Condensation has occurred on the lens. Leave the projector for
	about two hours with the power on.
The picture flickers.	c Adjust “Dot Phase” for “Adjust Signal” in the signal				menu
	properly. (1 page 39)

Troubleshooting 45

Others