Message ListsWarning messages

Message

Cause and Remedy

 

 

 

 

High temp.! Lamp off in 1

c Turn off the power.

 

min.

c Check to see if nothing is blocking the ventilation holes.

 

 

Frequency is out of range!

c Input a signal that is within the acceptable range of the

 

frequency.

 

 

c Set the output signal on an external monitor of the connected

 

computer to SVGA.

 

 

c Set “Input-A Signal Sel.” in the Setup

menu to

 

“Computer”. (1 page 42)

 

 

 

 

Please check Input-A

c Set “Input-A Signal Sel.” in the Setup

menu to

Signal Sel.

“Computer” when RGB signal is input from the computer. (1

 

page 42)

 

 

 

Please replace the LAMP.

c It is time to replace the lamp. Replace the lamp. (1 page 48)

 

Tip

 

 

c To erase the message from the screen, press any button on the

 

remote control or the control panel.

 

 

 

Please replace the filter.

c It is time to replace the air filter. Replace the air filter. (1 page

 

49)

 

 

Tip

 

 

c To erase the message from the screen, press any button on the

 

remote control or the control panel.

 

 

 

High temp.!

c When using the projector at an altitude of 1,500 m or higher:

Probably use in high

select “Yes” to set to “High Altitude Mode”. (1 page 41)

altitude. Switch to high

c If this message is displayed when using the projector at an

altitude mode on? Yes: O/

altitude of less than 1,500 m: check to see if nothing is blocking

No: o

the ventilation holes.

 

 

 

 

Caution messages

Message

Cause and Remedy

 

 

x

c No signal is input in the selected input. Check connections. (1

 

page 13)

 

 

Not applicable!

c Press the appropriate button.

 

 

Others

Troubleshooting 47