64
Warning messagesCaution messagesMessage Lists
Message Cause and Remedy
High temp.! Lamp off in 1
min.
cTurn off the power.
cCheck to ensure that nothing is blocking the ventilation holes.
(1 page 12)
Frequency is out of range! cFrequency is out of range. Input a signal that is within the
acceptable frequency range of the projector. (1 page 72)
Please check Input-A
Signal Sel.
cSet “Input-A Signal Sel.” in the Setup menu to
“Computer” when an RGB signal is input from a computer.
(1 page 51)
Please replace the Lamp/
Filter.
cIt is time to replace the lamp. Replace the lamp. (1 page 65)
cAlso, replace the air filter too. Restart cleaning the ventilation
holes (intake). (1 page 65)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 65)
To clear this message, press any button either on the remote control
or the control panel of the projector once.
Please clean the filter. cIt is time to clean the air filter. Clean the air filter. (1 page 68)
To clear this message, press any button either on the remote control
or the control panel of the projector once.
Please clean the filter. Have
you finished? Yes No
cIt is time to clean the air filter. Clean the air filter. (1 page 68)
cIf you cleaned the air filter, select “Yes.” If you did not clean the
air filter, select “No.”
Projector temperature is
high. Cooling Setting
should be “High” if
projector is being used at
high altitude.
cCheck to ensure that the ventilation holes on the unit are not
covered. (1 page 12)
cWhen using the projector at high altitude, set the Cooling
Setting to “High”. (1 page 50)
When temperature inside the projector remains high, the Cooling
Setting is switched to “High” in 1 minute, then the fan speed
increases.
Message Cause and Remedy
cNo signal is input in the selected input. Check connections.
(1 page 22)
Not applicable! cPress the appropriate button.
cThe operation to be activated by the button is currently
prohibited.
Note
Note
Note
x