Sony VPL-SW125 Location and Function of Controls

Location and Function of Controls

Overview

BOverview

Location and Function of Controls

aProjection lens

bFocus ring (page12)

cLamp cover (page 34)

dAir filter cover (page 36)/

Ventilation holes (intake)

eVentilation holes (intake)

fVentilation holes (exhaust)

Do not place anything near the ventilation

holes as this may cause internal heat

buildup. Do not place your hand near the

ventilation holes and the circumference as

this may cause injury.

gLAMP/COVER indicator

(page 30)

hControl panel (page5)

iConnector panel (page4)

jRemote control detector

kAdjuster (page 12)

lSpeaker

mSecurity lock

Connects to an optional security cable

manufactured by Kensington.

For details, visit Kensington’s web site.

http://www.kensington.com/

nSecurity bar

Connects to a commercially available

security chain or wire.

If it is difficult to pull out, pull out the

Security bar using a screwdriver.

Main unit

Caution

Security bar

Contents

Main 2 Table of Contents Overview Preparation Projecting/Adjusting an Image Adjustments and Settings Using a Menu Location and Function of Controls Main unit 4 Connector Panel 2 6 8 17 5 4 6 3 8 17 5 Remote Commander and Control Panel 123 3 6 6 fSetting the energysaving mode easily Others gInfrared transmitter BPreparation Connecting the Projector Connection with a computer is explained for each input signal. INPUT A/INPUT B (INPUT B is available only for VPL-SX125) For connecting a computer with an RGB output connector. Connecting a Computer 8 Connections with a VHS video deck, DVD player, or BD player are explained for each input signal. For connecting video equipment with a YPBPR output connector. S VIDEO IN For connecting video equipment with an S-video output connector. INPUT B (VPL-SW125 only) For connecting video equipment with an HDMI output connector. 10 OUTPUT Note Connecting an External Monitor and Audio Equipment Projecting an Image 12 Adjusting the tilt of the projector with the adjusters Adjusting the Projected image Changing the aspect ratio of the projected image Correcting trapezoidal distortion of the projected image (Keystone feature) 14 Turning Off the Power 1 2 BAdjustments and Settings Using a Menu Using a MENU 1 menu. 2 3 The PICTURE SETTING Menu For adjusting the picture for each input signal. The INPUT SETTING Menu For adjusting the size, position, and aspect ratio of the projected image for each input signal. Page Aspect VPL-SX125 20 VPL-SW125 The SET SETTING Menu The SET SETTING menu is used for setting various functions of the projector. 22 The MENU SETTING Menu 24 The INSTALL SETTING Menu The INSTALL SETTING menu is used for installing the projector. Page 26 The INFORMATION Menu BNetwork Using Network Features 1 2 projector using Network Setting on the SET SETTING menu (page 21). 3 1 Confirming the Information regarding the Projector Operating the Projector from a Computer Using the e-mail report Function 2 the Send To box then check the Report Timing check box of the e-mail report to be sent. 3 4 mail reports. Indicators Messages List 32 Troubleshooting Page 34 Replacing the Lamp pull out the lamp by its grab. If the lamp breaks, contact qualified Sony personnel. Do not replace the lamp yourself. 1 the AC power cord from a wall outlet. 4 5 6 7 36 Cleaning the Air Filter 1 2 3 4 Specifications 38 Page 40 Pin assignment RGB input connector (Mini D-sub 15-pin, female) RS-232C connector (D-Sub 9-pin, female) Acceptable Input Signals Computer signal Digital TV signal Analog TV signal 42 Projection Distance Floor Installation (Adjuster (rear) fully extended) Page 44 Ceiling Installation (Top side parallel to ceiling) Page 46 Dimensions Others Dimensions 48 Index A B C D P R S T U