Sony VPL-VW40 On-screendisplay, Remote control

Symptom	Cause and Remedy
The color gradation of the	c The color gradation of the dark area or the bright area may
dark area or the bright area	become unclear when a signal other than those from HDMI
of the picture from the	standard is input. Adjust the “Brightness” and the “Contrast” in
HDMI 1 or HDMI 2	the Picture	menu. (1 page 41)
connector becomes
unclear.
The picture is too dark.	c Adjust the “Contrast” or “Brightness” of the Picture		menu
	properly. (1 page 41)
The picture is not clear.	c Adjust the focus. (1 page 24)
	c Condensation has accumulated on the lens. Leave the projector
	for about two hours with the power on.
The picture flickers.	c Activate “APA”, then adjust the current input signal.
	c Adjust “Phase” for “Adjust Signal” in the Screen		menu
	properly. (1 page 45)

On-screen display

Symptom	Cause and Remedy
On-screen display does not	c Set “Status” in the Setup	menu to “On.” (1 page 46)
appear.	c Check if the ?/1 (ON/STANDBY) indicator should light in
	green.
The model name does not	c The display mode of the projector may be set at the time of
disappear from the screen.	purchase. Consult with your local dealer or qualified Sony
	personnel.

Remote control

Symptom	Cause and Remedy
The remote control does	c Batteries could be weak. Replace them with new batteries.
not work.	(1 page 11)
	c Insert the batteries with the correct polarities. (1 page 11)
	c In the Installation	menu, set the setting of “IR Receiver” to
	“Front & Rear”. (1 page 49)
	c If there is a fluorescent lamp near the remote control detector, the
	projector may work improperly or inadvertently. Change the
	setting of “IR Receiver” in the Installation		menu. (1 page 49)

Others

53