1-7
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
1-5. Round Type Connector (12-Pin)
1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the rear panel assembly.
(Refer to Section 1-2-2.)
3. Remove the CN-3020 board. (Refer to Section 1-3-5.)
4. Remove the nut and washer, then remove the round
type connector (12-pin).
5. Attach the round type connector (12-pin) in the reverse
order of steps 1 to 4.
1-6. Matching Connectors and Cables
When external cables are connected to the connector of
each unit, the hardware listed below (or equivalents) must
be used.
Connector Matching connector/cable
IEEE1394b IEEE1394b cable (9P-9P)
(Commercially available products)
IEEE1394b cable (9P-6P)
(Commercially available products)
DC IN Camera cable
CCXC12P02N (2 m)
CCXC12P02N (5 m)
CCXC12P02N (10 m)
CCXC12P02N (25 m)
Round type
connector (12-pin )
Rear panel
NutWasher
1-7. Signal Inputs and Outputs
11
11
1IEEE1394b connector
.IEEE1394b-2002
Pin No. Signal name Remarks
1 TPB (_) Twisted pair B (_)
2 TPB (+) Twisted pair B (+)
3 TPA (_) Twisted pair A (_)
4 TPA (+) Twisted pair A (+)
5 TPA (R) Twisted pair A (Ground reference)
6 VG Power ground
7 N.C.
8 VP Power voltage input
9 TPB (R) Twisted pair B (Ground reference)
22
22
2DC IN: 12-pin (male)
Pin No. Signal Pin No. Signal
1 POWER_GND 7 GPIO_IN2
2 POWER_IN 8 GPIO_OUT2_
3 ISO_GND 9 GPIO_OUT2+
4 STROBE_OUT 10 GPIO_IN1
5 GPIO_OUT1_11 TRIGGER_IN
6 GPIO_OUT1+12 ISO_GND
2
1
— External view —
41
59
— External view —
3!-
5
!/
!=
19
46
28
7