Sony Section 2 Adjustment

2-1
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
Section 2
Adjustment
Camera
IEEE1394b
cable
IEEE1394b
Personal computer
2-1. Writing of Serial Number and Node
Unique ID
n
Perform the writing when replacing the FM-96 board or
front panel assembly.
Required equipment
.Personal computer (PC)
.IEEE1394.b board
.IEEE1394b cable (Commercially available products)
.IIDC_CAM**** software: J-7120-410-A
(**** represents the version number.)
Connection
Preparation
1. Connect each device as shown in the above illustra-
tion.
2. Install the IIDC control software in an arbitrary place
of PC.
Procedure
1. Start the IIDC_CAM****software.
The IIDC control window is displayed.
No.
Node Unique ID
Serial
number
Model nameplate affixed
to the bottom of this unit
Node Unique ID
Lens side
Rear side
xxxxxxxx xxxxxxxx
xx
xxxxxxxx xxxxxxxx
xx
Adjust tab
2. Click the “Adjust” tab and “Enter Adjust mode” tab.
The unit enters the adjustment mode.
3. Check the model nameplate on the bottom of this unit.
Type the Node Unique ID in the Node Unique ID box
and type the serial number in the Serial Number box.
4. Click the [Write] button.
xxxxxxxx xxxxxxxx
xx
Type the serial number.
Type the Node Unique ID.
[Write] button