1-2 XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
1-2-2. Rear Panel Assembly
1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the two screws, then pull out the rear panel
assembly.
3. Disconnect the flexible flat cable from the connector
(CN900) on the CN-3020 board.
4. Attach the rear panel assembly in the reverse order of
steps 1 to 3.
n
When attaching the rear panel assembly, securely
attach it while pushing it against the chassis.
CN-3020 board
CN900
Rear panel assembly
Flexible flat cable
PM2 x 4
PM2 x 4
Rear panel assemblyChassis
1-2-3. Front Panel Assembly
n
When replacing the front panel assembly, perform the
writing the serial number and Node Unique ID and camera
adjustment. For details, refer to Sections 2-1 and 2-2.
1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the two screws, then pull out the front panel
assembly.
3. Disconnect the flexible flat cable from the connector
(CN101) on the BI-217/218/219 board.
4. Attach the front panel assembly in the reverse order of
steps 1 to 3.
n
When attaching the front panel assembly, securely
attach it while pushing it against the chassis.
PM2 x 4
PM2 x 4
Front panel assembly
CN101
Flexible flat
cable
BI-217/218/219 board
This illustration is for XCD-SX90/SX90CR.
ChassisFront panel assembly