Enhancing your system
Headphones
Before plugging in or unplugging the headphones, reduce the vol- ume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and impedance between 16 and 50 ohms. The recommended imped- ance is 32 ohms.
Plugging in the headphones disconnects the speakers automati- cally. Adjust the volume using the VOLUME control.
Troubleshooting chart |
Many potential problems can be resolved by the owner without call- ing a service technician.
If something is wrong with this product, check the following before calling your authorised SHARP dealer or service centre.
General |
|
|
|
|
|
Symptom | Possible cause |
|
|
|
|
The clock is not set to the | Did a power failure occur? Reset |
|
correct time. | the clock. (Refer to page 12) |
|
|
|
|
When a button is pressed, | Set the unit to the power stand- |
|
the unit does not respond. | by mode and then turn it back on. |
|
| If the unit still malfunctions, reset |
|
| it. (Refer to page 30) |
|
|
|
|
No sound is heard. | Is the volume level set to "0"? | References |
| Are the headphones connected? | |
|
| |
| Are the speaker wires discon- |
|
| nected? |
|
|
|
|
CD player |
|
|
|
|
|
Symptom | Possible cause |
|
|
|
|
Playback does not start. | Is the disc loaded upside down? |
|
Playback stops in the | Does the disc satisfy the |
|
middle or is not performed | standards? |
|
properly. | Is the disc distorted or |
|
|
| |
| scratched? |
|
|
|
|
Playback sounds are | Is the unit located near excessive |
|
skipped, or stopped in the | vibrations? |
|
middle of a track. | Is the disc very dirty? |
|
|
| |
| Has condensation formed inside |
|
| the unit? |
|
|
|
|
29
