3-238-178-11(1)

FM/AM Cassette

Car Stereo

Installation/Connections
Installation/Connexions

XR-CA430X

Sony Corporation © 2002 Printed in Thailand

2

A

AUDIO OUT REAR

B

BUS AUDIO IN
BUS CONTROL IN

BUS AUDIO IN

Source selector*

Sélecteur de source

BUS CONTROL IN

* not supplied

non fourni

1

1 2 3

⋅ 4

⋅ 2

Cautions
•This unit is designed for negative ground 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g., seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

Run all ground wires to a common ground
Connection example (2)

Notes (2-A)

Be sure to connect the ground cord before connecting the amplifier.

If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

Tip (2-B- )

For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary.

45

Equipment used in illustrations (not supplied)
Appareils utilisés dans les illustrations (non fournis)

Front speaker

Power amplifier

Haut-parleur frontal

Amplificateur de puissance

Rear speaker

CD/MD changer

Haut-parleur arrière

Changeur de CD/MD

point.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

Notes on the power supply cord (yellow) •When connecting this unit in combination with

other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Parts Iist (1)
The numbers in the list are keyed to those in the instructions.
Caution
Handle the bracket 1 carefully to avoid injuring your fingers.

1

Connection diagram (3)

1To a metal surface of the car

First connect the black ground lead, then connect the yellow and red power input leads.

2To the power antenna control lead or power supply lead of antenna booster amplifier Notes

It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-operated telescopic antenna.

When your car has a built-in FM/AM antenna in the rear/side glass, see “Notes on the control and power supply leads.”

3To AMP REMOTE IN of an optional power amplifier

This connection is only for amplifiers. Connecting any other system may damage the unit.

4To the +12 V power terminal which is energized in the accessory position of the ignition key switch

Notes

If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times.

Be sure to connect the black ground to it first.

When your car has a built-in FM/AM antenna in the rear/side glass, see “Notes on the control and power supply leads.”

5To the +12 V power terminal which is energised at all times

Be sure to connect the black ground to it first.